In this post two things will be addressed one is how you can wake your dead or fried original strong decoders via pc and rs-232 cable.
Warning: this post is not for you if you have a fake / clone strong decoder because your box will not wake up.
But for those who have the genuine decoders, complete the instructions below on how you can wake up your dead strong decoders… now your strong decoder may die as a result of several reasons including but not limited to the fact that you may be trying to input or upload something that is corrupt or incompatible into it. E.g you are trying to update its firmware via a usb flash drive that is infected with virus.
There are two major ways to wake a fried strong decoder
i. Through a computer Using RS-232 cable
ii. Thruough decoder to decoder via inter-decoder firmware transfer
i. Through a computer Using RS-232 cable
ii. Thruough decoder to decoder via inter-decoder firmware transfer
Procedures and requirements on how to wake a dead strong decoder with another strong decoder
1. Get an rs-232 cable
2. Get another working decoder of that same type
3.connect the two decoder via rs232 and remember to swich off the fried one
4. Switch on the good one. Go to – system setting>> data transfer >>firmware press ok. Wait till it finish loading. That’s all. Drop your comments
2. Get another working decoder of that same type
3.connect the two decoder via rs232 and remember to swich off the fried one
4. Switch on the good one. Go to – system setting>> data transfer >>firmware press ok. Wait till it finish loading. That’s all. Drop your comments
PROCEDURES TO WAKE A FRIED DECODER WITH A PC VIA RS-232 CABLE USING STRONG LOADER:
To do this via a pc you will need to have some basic things:
i download the strong loader for srong in middle east and africa click SRTLoader_Software_Uploaders_Middle East & Africa but for others get them HERE
ii Now download the software compatible with your decoder model from the list there
iii save both the loader and the software on your pc desktop for easier access
iv launch the srt loader and click on the browse button, locate your software and select
v. Now conect your decoder with the rs-232 cable and press auto detect on the loader menu. once your decoder is detected press on download and wait for the process to complete.
Warning, do not for any reason switch on the box before or during the process even if the box is not totally dead prior to theis process switch it off before the process
